Cast Polypropylene (PP) Film Properties
Cast 300 Series P/P Film Properties
Physical Properties (1.0 Mill Film)
| Property | Units | ASTM Test | Typical Value | |
| Haze | % | D 1003 | 2.5 | BFI 301: General Purpose Film |
| Gloss | 45° | D 2457 | 85 | |
| Ultimate Tensile MD TD |
PSI | D 882 | 6500 5500 |
BFI 340: Very Low Gel Count. For lamination and application requiring an extra clean film. |
| Ultmate Elongation MD TD |
% | D882 | 650 700 |
|
| Secant Modulus MD TD |
PSI | D882 | 70,000 65,000 |
|
| Coefficient of Friction | gm | D 1984 | 0.18- 0.25 | |
| Dart Impact | F50 gm @ 20° | D 1709 | 150 | |
| Elmendorf Tear Strength MD TD |
gm | D 1922 | 20 90 |
|
| Oxygen Transmission | cc/100 sq.in/24 hrs | 180 | ||
| Moisture Vapor Transmission | gm/mill 100 sq.in/ 24 hrs |
E 96 | 0.8 | |
| Seal Intiation Temp. (S.I.T.) | °C | 125 | ||
| Yiled | sq.in/ lb | 30,800 |
NOTE:
Technical data is furnished for the end user's information. No guarantee is made of its accuracy. BFI does not accept responsibility for results obtained by the application of this information or the safety and suitability of our products either alone or in combination with other products. Because conditions may vary and are beyond our control, users are advised to make their own determination of the safety and suitability of each product or product combination in their own application.
Cast HP100 Series P/P Film Properties
Physical Properties (1.0 Mill Film)
| Property | Units | ASTM Test | Typical Value | |
| Haze | % | D 1003 | 3.5 | BFI HP101: General Purpose Film |
| Gloss | 45° | D 2457 | 75 | |
| Ultimate Tensile MD TD |
PSI | D 882 | 7000 5500 |
BFI HP102: Candy twist wrap. Available in narrow and wide width. |
| Secant Modulus MD TD |
% | D 882 | 550 750 |
|
| Coefficient of Friction | gm | D 1984 | 0.60 | BFI HP140: Very Low Gel Count. For lamination and application requiring an extra clean film |
| Elmendorf Tear Strength | gm | D 1922 | 20 85 |
|
| Moisture Vapor Transmission | gm/mill 100sq. in 24 hrs |
E 96 | 0. | |
| Yield | sq.in/ lb | 31,000 |
NOTE:
Technical data is furnished for the end user's information. No guarantee is made of its accuracy. BFI does not accept responsibility for results obtained by the application of this information or the safety and suitability of our products either alone or in combination with other products. Because conditions may vary and are beyond our control, users are advised to make their own determination of the safety and suitability of each product or product combination in their own application.
